Gauge Components

4ft serial patch cable (4pin to 4pin) for LM-2, LC-2, and MTX series gauges.

It is also possible to verify which sensor is currently being used by connecting your Innovate product to the LM Programmer software.

The Serial Program Cable will allow you to connect the MTX series gauges, LM-2, LC-2 SCG-1, PSB-1, and PSN-1 to your PC.

Inductive Clamp Engine RPM Pickup Accessory for LM-2.

Molex 4 pin to 2.5mm patch cable allows you to mate the newer style serial connector (Molex 4 pin) to the older style used in the LC-1, LMA-3, DL-3...

It is also possible to verify which sensor is currently being used by connecting your Innovate product to the LM Programmer software.

OBD-II / CAN Interface Accessory Cable for LM-2.

Not all SD cards are compatible with Innovate Motorsports products. This card has been tested and approved for use.

The Serial Program Cable will allow you to connect any of the following Innovate Motorsports devices to your PC. (LC-1, XD-16, LMA-3, DL-32, SSI-4,...

This Adapter is recommended for connecting computers without Serial ports to Innovate Motorsports devices using LM Programmer or Logworks softwares...

Innovate 4 BAR MAP Sensor for MTX-D / SCG-1

Innovate Replacement Ethanol Sensor Cable for MTX-D/ECB-1/ECF-1